Directing flow in closed loop system

Discussion in 'Lighting, Filtration & Other Equipment' started by clancaster23, Jan 9, 2014.

  1. clancaster23

    clancaster23

    Joined:
    Jan 16, 2011
    Messages:
    760
    Likes Received:
    9
    I just got my tank filled and finally started a cycle for the most part. This is a closed loop system with four return bulkheads in it. Two are up high near opposite ends of the tank and the other two are about half way up the tank and a quarter ways in, one on each side. I wanted to find out how I can direct the flow of each bulkhead so I can maybe them in directions that I want them. Is loc-line what I would use for this? The inside of my bulkheads are slip fittings, obviously I won't be able to glue the fittings inside but is it possible to somehow attach the fittings while still in water?
     
    clancaster23, Jan 9, 2014
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.