Hi all,
I've just scored a behemoth of a tank and there is a small suspect chip right in one of the bottom corners.
It holds water fine but I'm just a little bit worried.
Whats the protocol for fixing this?
Possibly put a folded, half-cubed, perspex inner over the entire bottom corner and silicon in to take the pressure off?
Wade.
I've just scored a behemoth of a tank and there is a small suspect chip right in one of the bottom corners.
It holds water fine but I'm just a little bit worried.
Whats the protocol for fixing this?
Possibly put a folded, half-cubed, perspex inner over the entire bottom corner and silicon in to take the pressure off?
Wade.